- Resource Center
- GracePESDs CheckVolt
-
GracePort®
-
GracePort+
-
GracePESDs® - Voltage Indicators
-
GracePESDs® - Safe Test Point and Voltage Test Station (VTS)
-
GracePESDs® - Voltage Portal and Combo Units
-
GraceSense™ - Hot Spot Monitor (HSM)
-
GraceSense™ Predictive Maintenance System
-
General
-
Videos
-
Webinars
-
Case Studies
-
Webinar FAQs
-
Press Releases
-
GracePESDs CheckVolt
-
GracePESDs
-
Proxxi by Grace
Alternative mounting options for the ChekVolt®!
If the ChekVolt does not have enough room for the flange mount, here are alternative mounting options below:
You can find the link to the ChekVolt installation manual here.
Option 1: Flange Label [R-3MT-LF]
- The flange width measured with the door closed on the industrial cabinet should be greater than 2.14 in.[55mm].
- Align the center of the cutout at 0.95 in.[24mm] from the outside edge of the cabinet flange to prevent interference with the cabinet door.
Option 2: Dust Cap [R-3MT-CAP]
- The dust cap is solid black and not see-through.
- The flange width measured with the door closed on the industrial cabinet should be greater than 1.9 in.[48mm].
- Align the center of the cutout at 0.95 in.[24mm] from the outside edge of the cabinet flange to prevent interference with the cabinet door.
Option 3: Horizontal Label [R-3MT-LH]
- If there is no room for a flange mount, the ChekVolt can be mounted on the cabinet door using the Horizontal Label option.